Kuhn Farm 4142
4-Auger Horizontal TMR Mixers Kuhn Farm 4142
Double tap to zoom
Efficient Feed Movement
The raised lower right auger configuration, along with the close tolerance between the auger flighting and the auger troughs, results in a fast and complete cleanout. The offset upper right auger in combination with the raised lower auger requires less horsepower and provides a faster mix time.
The close auger tolerances and raised lower auger design provide a fast, consistent discharge from beginning to the end of unloading. This results in even feed placement across the entire length of the bunk without a delay for mixer control. The three-auger discharge allows adjustment for feeding into higher bunks. It has a simple, hydraulic drive that provides sooth, even discharge and the augers are easy to remove for fast service.
The versatile swivel discharge will discharge to the left, right or rear of the Primor, allowing use in difficult-to-access areas. Controlled from the tractor, bedding can be blown up to 42’ through a full 300° range.
As with the main auger drive, the discharge auger shafts are splined for a more positive power transfer and longer service life. The simplified drive design, featuring only two chains and a remote grease bank, results in easy service and maintenance.
Splined Drive Shafts
The splined shafts allow a strong, reliable torque transfer and provide easier sprocket alignment and maintenance.
|Capacity - no extensions (m3)||11.9|
|Capacity - no extensions (cu.ft)||420|
|Number of augers||4|
|Overall height - no extensions (cm)||249|
|Overall height - no extensions (in)||98|
|Overall width - without options (cm)||229|
|Overall width - without options (in)||90|
|Tread width (cm)||221|
|Tread width (in)||87|
|PTO speed (rpm)||540 / 1000|
|Minimum power requirement for PTO (kW)||60|
|Minimum power requirement for PTO (hp)||80|
|Maximum load (kg)||5715|
|Maximum load (lb)||12600|
|Door opening (h x w, cm)||80 x 82|
|Door opening (h x w, in)||31.5 x 32.25|
|Auger diameter - lower (cm)||61|
|Auger diameter - lower (in)||24|
|Auger diameter - upper (cm)||61|